rolling surface

The results showed that, the tip vortex at the blade's leading edge near the suction surface tip region is generated by the rolling up effects between the main flow fluid along the meridian surface and the outer fluid of the blade's outer region.

结果表明：沿子午面流动的主气流与从叶顶外侧吸入的气流之间的卷吸作用导致在吸力面叶顶区域产生了叶尖涡。

Cross breaks are formed on the surface of cold rolled and tempered strip during temper rolling, which influence the surface quality and mechanical characteristics of the temper rolled strip.

冷轧退火后的带钢在平整过程中产生横折印缺陷，严重影响平整后带钢的表面质量及其力学性能。

The quality requirement of tire cord steel have been discussed in this paper. Factors influencing the quality of tire cord steel was also analyzed, such as inclusion size, morphology, and structure, surface quality, segregation of hot rolling wire rods.

阐述了帘线钢的质量要求，并对影响帘线用钢质量的各种因素进行了分析：主要包括钢中夹杂物的尺寸、形态，热轧线材的组织及表面质量、偏析程度等；

The test of rolling the differential thick lead sheet shows the internal surface hollow and hole defect is resulted from uneven deformation of rolled piece. The basic way to avoid the two defects is put forward.

通过轧制差厚铅板实验说明规律性的热连轧无缝钢管内表面凹坑、孔洞缺陷的形成主要是由于轧件不均匀变形所致，并提出避免这两种缺陷出现的基本思路。

The surface is covered with ink by rolling over the surface with an ink-covered roller ( brayer), leaving ink upon the flat surface but not in the non-printing areas.

表面的轧制离开平坦的表面，但不是在非打印区域的墨水用油墨覆盖的滚子（稿样），表面上满是油墨。

Application of characteristic parameters of surface shape and appearance in thin steel plate rolling

表面形貌特征参数在薄钢板轧制中的运用

Surface Quality and Microstructure Analysis of Casting and Rolling Stainless Steel Strip

铸轧不锈钢薄带表面质量与显微组织分析

The rolling contact theory of three-dimensional elastic bodies with non-Hertz form is utilized to determine the normal pressure and tangential traction on the contact surface of wheels and rails in rolling contact.

根据确定的轮轨接触几何参数和轮轨接触界面之间的蠕滑率，利用非Hertz滚动接触理论分析计算了锥型轮对和钢轨滚动接触斑作用力的分布。

Rolling experiments were carried out based on the analysis of rolling force and power in a three-roll planetary mill. The result shows that dimensions, surface quality and tolerances of piPes rolled with the mill can all meet the specified requirements.

在理论分析三辊行星轧制的轧制力和轧制功率的基础上，进行了轧制试验，结果表明，采用三辊行星轧机轧管，无论是尺寸范围，还是表面质量、公差均能达到预期目的。

A crystallographic model has been presented for the surface roughness modelling of thin sheet rolling.

提出了晶体学模型来研究多层薄膜滚压的表面粗糙度。